Airsoft - BOYI All Metal M4 SOPMOD Review
Review By: ZEKE
My brief review of BOYI All Metal M4 SOPMOD.
First what’s in the box?
The M4 SOPMOD unit
M4 Hi-Cap magazine
8.4 1100 mah mini battery (crane stock configuration)
Charger
Small bag of .2bbs
Vertical Grip
Rail Cover
Tactical Sling
Cleaning Rod
Manual
EXTERNALS
The gun:
The gun is painted flat black, finished is good. So it looks nice and rugged. Upper and lower receiver are made of Aluminum cast metal, i guess, so as the free floating R.I.S and the Silencer. The feel of this gun is almost the same as the GnP M4 SOPMOD. Even if its metal body its not so heavy and the balance of the gun is good. I don’t know the reason behind this. Maybe I’m get used with my CA M4 Carbine which is comparably more heavier than the BOYI. Or maybe to its SOPMOD design in which the gun has no metal front sight, and no carry handle. .
The Free floating R.I.S
Upon checking the gun body and parts alignment, I’d noticed that rails of the R.I.S are not properly aligned with the rail of the upper receiver. I don’t know with the other unit but in my case there’s about 5 degrees offset when you look at it at its front end.
Traces of weld on the R.I.S can be seen also protruding due to reinforcement of metal since its free floating. I need to grind and polish this and then repaint it. There’s no problem on its vertical grip. It fits snugly on the rail of the R.I.S.
The Magazine:
The standard high capacity M4 mag made of metal and plastic. Test fired the unit fill the magazine with the entire freebie BB’s and roll it till it makes a tick then burst it non stop to my test target box till empty. The result is very satisfying since it empty the magazine till the mag coil lose wind. The only problem that i found is that it wobbled widely inside the mag well. I don’t know if the magazine itself is too small for the mag well or the mag well of the gun itself is having the problem. I need to check it with CA and TM Magazine. There’s a huge gap between the magazine and the magwell, you can even insert a scissor between them.
The Crane Stock:
The Crane Stock is a little bit slimmer than that of CA CQB Crane stock. And have different battery configuration from that of CA. I don’t know if Sub-C type battery will fit in it, since the package freebie battery is mini type. The gun might have looked better if it goes with a standard Crane stock.
Performance:
I chronoed the gun at the dealer shop and it clocks 320fps. Test fired it using lipoly 11.1V 2300 mah and WTF! What a crazy ROF. You can even call it a laser gun. . I know it’s obvious that I used lipoly battery on stock spring, but my point is, no event of misfeeding at that high rate of fire. . .
Share This
Comments(2)
